Protection Sheet

PVC L-BEAD  is specially developed to substitute for the conventional aluminum L-Bead whose metallic colour seldom matches the colour of the wall. The PVC L-Bead is economical and offers easy installation and painting characteristics.

Z-BEAD  creates a 12mm reveal or relief detail in drywall and at the same time encases the raw edges of the drywall. The wide perforated flange allows topping of key to board, eliminating the need of taping the flanges. It is also used at the juncture of dissimilar materials and can be used in either vertical or horizontal position.

ANGLE BEAD   is specially manufactured with striation and perforation along flanges, which provide positive bonding of the product to subtraits and skim coat plaster to the product. It also creates excellent alignment at corners or angles of the structure after finishing is done.

TILE TRIM   is specially designed to provide smooth chamfering at the corners of tile. Tile is a non-homogeneous material, making it extremely difficult to chamfer off neatly at the 90 degree corner. It comes in numerous colour selections to either blend or contrast with your tile’s colour theme.

STAINLESS STEEL (CJS-25)   and  BRASS (CJB-25) STRIP i are newly innovated products that are cost saving and environmentally friendly. Stainless steel and brass wrap over a PVC structure, with flexibility in height due to adjustable flanges. This is an economical and elegant floor and wall trimming, with uses such as parquet to parquet and parquet to tiles.

CJT-11G is designed to relieve stress in-between tiles. Its built-in cavity serves as a buffer that provides good spacing to protect the tiles from movements caused by expansion and contraction. It also has a perforated line on one side of the flange for easy breakage when installing in the perimeter or near the wall.

TILE SPACER is a small cross-like or A-shaped piece which is used to space tiles apart in equal distances. Spacers are used to accomplish a well-installed and attractive tile arrangement on floors, walls or countertops. Placing the tile spacer between tiles creates uniform grout lines when tiles are laid, which contribute to an overall neat and proportional appearance of the installed tiles. Spacers allow more precise alignment of individual tiles and a higher degree of accuracy during tile installation. They can also significantly speed up the work, because spacers eliminate the guess-work in tile placement.

INNER BEAD was developed to counter the difficulties of alignment of 90° internal corners during wall plastering. The Inner Bead was designed to give a perfect 90° internal corner even in cases where the wall does not meet perfectly at the corner. The efficiency of this product can save considerable time and money.

D RIP LINE and the Corner Bead have been integrated into a single ingenious product. As a result, both straight corners and the groove for drip line can be achieved in a single plastering procedure. To cater for a broader range of applications, we specially designed our Drip Line in 2 sizes, one for the window ledge (DL-1310), which has a shorter distance between the window frame and the edge, and the other catering for a normal ledge.

PLASTER STOP is able to terminate plaster or stucco works. K.U.S’s series of Plaster Stops includes 6mm, 10mm, 12mm, 15mm and 35mm to create skirting along the wall, grooves on the ceiling, window and door jambs, as well as addressing the juncture of dissimilar materials.

BRICK MESH is an essential reinforcement component for masonry work, to minimise cracks caused by stresses, vibration and thermal movement of brick walls. It is commonly applied in bricklaying and plastering works, especially between brick layers, the junction between brick and concrete, joints between dissimilar materials, and areas along lines of stress.